Well here is the start of it all. This is the only point I can back out of serious damage to the body, from here on in you can not go back!

You have to trust the template.. It seems to be wrong, but they are in the correct spot.

 Use a spring loaded punch to mark the small hole.

Once you have the small hole marked, remove the template and drill a 3/16" hole  as a pilot hole for the hole saw.  

**You should match it to your hole saw to stop it from "grabbing" 

Now for the big one! I did not get a photo of the deed, but the results are obvious..You need to hold the drill level to the ground, don't level the hole saw to the fender, it will drill a different hole shape and may not fit.

Now you can drill out the holes for the mount bolts.. I had marked them with a sharpie and used a "Uni-Bit" and brought them up to 1/2" in diameter.  

You can file to make it fit, they give you washers that are like 2" in diameter!