The Cruiser came back from Cruiser Solutions Saturday May 10th. I snagged some shots from Tedd's web site so I could show the before and after shots of some of the body work.
You can see the passenger side cowl panel in this shot. Both panels looked basically the same with the rot at the bottom of the cowl panel next to the fender.
Here's the passenger side floor board. The Gatorade bottle is catching the anti-freeze that leaks out of the heater pipes.
Here's the passenger side mount to the frame. Tedd left the body mount off because I will drill mount holes once I mate the tub. This will be critical to get the doors to hang properly again.
The following shots are the finished product.
(I threw a mount in place to see what was wrong with the front end. Seems either I put the front end back together crooked, or when the fender was remounted it was mounted slightly off. I'll find out once the tub/cowl are in place.
Below I have just some other shots of the truck.
Notice the alignment of the hood to the bib. Most of this is because the cowl is loose. However, the bib is definitely not square to the frame. This will be sorted out once the tub arrives.
Shot of the nice new Stock Toyota Fuel Tank. I was psyched to see that it came painted from the factory.